Through the equipment vendors would introduce how to solve the problem

　　Through the equipment vendors would introduce how to solve the problem

　　In recent years, the rapid industrial development, industrial development activities in the upgrading of equipment and product is very common, because the time is changing, if the device does not follow the market trend, the use of will be eliminated by the market. Drawing-in machine as a textile is used in the manufacturing process of a device, in the process of equipment work, problems are inevitable, specific what are the problems? This is everybody will be watching, and below small make up together to see through the machine operation there may be some of the problems, help you better use of the device.

　　1、Splice is not qualified or splice failure

　　Splice is not qualified or splice failure is caused by a variety of reasons. One is the improper process design, splice parameters is not reasonable. 2 it is to dial the yarn pole position is not correct, failed to twist yarn into the connector. Three is the splice rotation is not flexible, seal leakage oil in the short, splice cap damage or pop-up is ineffective. Reason is a man-made causes can change the splice parameters, and then do splice test, to test splice parameters is reasonable. Second solution is to dial the yarn pole screw loosening, correct location. Three reasons are often appear phenomenon, but also for key parts of maintenance work, so when maintenance according to the specific circumstances, can add lubricating oil if necessary.

　　2、Cone yarn grip arm size chuck rotation is not flexible

　　Cone yarn grip on the arm of the size of the chuck is high speed, the rotation speed and close to the speed of the slotted drum, so often appear bearing wear failure. After failure occurs, bobbin rotating difficulties, uneven yarn arrangement, alarm prompt will appear, as long as the bearing within the chuck out put on new can resume normal production.

　　All in all, we learned the many operators operating drawing-in machine, possible problems and splice is unqualified and chuck rotation is not flexible. These two types of problems at the time of processing, if not handled properly, will affect the normal work of the drawing-in machine, so I need attention, as a reliable, our drawing-in machine equipment to the user experience is very good.